';
side-area-logo

CLADIT

CLADDING FINISH WC44
wc44-cladit

A unique single pack water thinned polyurethane acrylic finish for long lasting protection of exterior cladding elevations.

  • Hard-wearing, flexible coating for use on steel structures and cladding.
  • No need for primer, apply directly to intact cladding. Suitable for both wall and roof areas.
  • Easy to maintain with excellent weathering resistance.
  • Quick drying, water based coating with low VOCs.

SUITABLE FOR:

Direct application to most external cladding including Plastisol and PVF2. Properly prepared, clean, dry, free of contamination and dust. Suitably prepared and primed steel, non-ferrous steel, fibreglass, concrete and mineral substrates.

APPLICATION:
Brush, Roller & Spray

SHEEN LEVEL:
Semi Gloss

COVERAGE:
10mper Litre

TOUCH DRY:
1 Hour

RECOAT:
4 Hrs Min.

AVAILABILITY:
5 Litre

POT LIFE:
N/A

ADDITIONAL INFO:
Thinner: Water

Sorted Metal Primer.

*At 40 microns DFT (loss factors will apply in practice)

Correct preparation is vital to ensure you obtain the full benefit from Bradite Cladit Coatings.

  • Thoroughly degrease using Bradite TD39 diluted with up to 9 parts water, rinse with clean water and allow to dry. This procedure should be carried out in conjunction with jet washing equipment at a pressure of no less than 1500psi and in such a way as not only to clean the surface but also to remove any loose and flaking material.
  • Ensure that the existing cladding coating itself is well adhered to the substrate (carry out a series of adhesion tests if necessary). Scrape failed areas to a firm edge, making sure all edges are feathered.
  • Spot prime any areas of exposed non-ferrous metal using two coats of correct Bradite primer.
  • In extreme cases the non-ferrous coating itself may have broken down exposing the underlying steel substrate. Any such areas should be manually or mechanically prepared to clean bright metal (SIS St3) and spot primed using correct Bradite primer.
  • Do not paint in adverse conditions. Temperature should be a minimum of 3°C above the dew point during application and cure. Rain on the surface shortly after application can affect the final appearance.
  • Avoid painting in areas exposed to direct sunlight as this may accelerate drying and make application difficult.
ALTERNATIVE PRODUCTS

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy