';
side-area-logo

FASTRAC

FAST DRYING ENAMEL – GLOSS FINISH ME53 / SATIN FINISH (SE53)
me53-fastrac

A modified silicone and polyurethane alkyd coating with rust inhibiting
pigmentation for added protection.

  • Tough, flexible coating, fast drying direct to bare or previously painted metal, wood and suitably primed non-ferrous metals.
  • Superior coverage of 13ml2 per Litre. Heat resistant to 120°C.
  • High opacity with outstanding application and flow out properties.
  • Fastrac’s silicone content ensures excellent exterior performance on all surfaces through superior UV and temperature resistance.

SUITABLE FOR:

Degreased suitably prepared clean new and previously coated metal, wood and suitable primed non-ferrous metals.

APPLICATION:
Brush, Roller & Spray

SHEEN LEVEL:
Gloss (ME53), Satin (SE53)

COVERAGE:
13mper Litre

TOUCH DRY:
2 Hours

RECOAT:
16 Hrs Min.

AVAILABILITY:
250ml, 1 & 5 Litre

POT LIFE:
N/A

ADDITIONAL INFO:
Thinner: TW35

*At 35 microns DFT (loss factors will apply in practice)

Red, Yellow, Blue, Green, Black, White, Silver and Gold.

ACE, BS & RAL.

Correct preparation is vital to ensure you obtain the full benefit from Bradite Metal Paints.

New and unpainted steel

  • High pressure water cleaning to remove all loose salts and other contaminants.
  • Degrease using BRADITE TD39, with scrubbing plus high pressure water cleaning to remove any oil contamination not removed by high pressure cleaning alone, rinse with clean water and allow to dry.
  • Mechanically or manually prepared steel to a clean metallic finish, SIS-St 3 minimum.
  • Substrate to be dry, clean and free of contamination and dust free prior to coating.

Existing coatings

  • Jet wash to remove all loose and flaking paint, salts and other contaminants.
  • Degrease using Bradite TD39 diluted with up to 9 parts of warm water and scrubbing to remove any oil contamination not removed with jet washing alone. Rinse with clean water and allow to dry.
  • Existing coatings should be well adhered with all edges tight and well feathered.
  • Bare or rusted steel should be manually or mechanically abraded to a clean metallic finish (SIS-St 3).
  • Substrate should be clean, dust free and dry before application.
  • Spot prime with correct primer.
  • Galvanised steel, aluminium and other non-ferrous metals should be roughened or lightly abraded.
  • New bright galvanised steel should be degreased and treated with Bradite TM38 pre-treatment for galvanised steel.
ALTERNATIVE PRODUCTS

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy

CLADIT

CLADDING FINISH WC44
just5lcladit-copy